ROAD SAFETY-Road Safety in Indian Cities

Sunday, August 15, 2010

Sanjay K. Singh
Associate Professor of Economics,Indian Institute of Management,Lucknow


Source-URBAN MOBILITY,IRF BULLETIN

More than 240 people get killed every week in India's metropolitan cities(cities with populations of a million or more).There are 34 fatalities per week on the roads of Delhi alone!But,Delhi is not the riskiest city in the country.No less than 16 other metropolitan cities present a higher risk than Delhi.The level of risk in the cities of Uttar Pradesh,the most populous state of India,is more than twice that of the other cities in the country(see Figure).

Why then is the road safety situation so bad in so many cities of India?The main reason appears to be the prevailing imbalance in modal split coupled with inadequate transport infrastructure and its sub-optimal use.Very few cities have an adequate public transport system.People reply primarily on personalised modes such as cars and two-wheelers and para-transit modes such as cars and two-wwheelers and para-transit modes such as auto-rickshaws and tempos.In most of the cities,two-wheelers and cars account for over 90% of the vehicle population,whereas the share of buses is negligible.In general,the road space in cities is grossly insufficient and the problem of traffic accidents is further aggravated by the mixed nature of traffic composition.Experience shows that fatalities tend to be concentrated around roads that are dysfunctional in the sense that they are not fit for carrying such mixed streams of intense fast and slow moving traffic safely.Typical features aggravating injuries and fatalities include traffic volumes and speeds that the roads were simply not designed for,high proportions of young and inexperienced drivers and high levels of non-motorised transport users,such as cyclists and pedestrians,vying for the same road space.

Most of the traffic accidents are attributed to human error.For this reason,road safety initiatives traditionally focus on 'fixing' the driver in order to prevent crashes.While there can be doubt that approaches involving road safety education and enforcement are essential in curtailing traffic accidents,there is an equal and parellel need for more focus on mitigating te outcome of accidents by designing safer vehicles and safer roads.

Roads should be designed in such a way that they are not only self-explaining but also'forgiving'.Accidents are less likely to occur on self-explaining roads and injuries will tend to be fewer and less severe on forgiving roads.A self-explaining road shows road users precisely where they should be at any given moment and guides them on how to procees safely.For example,a simple
cost effective pedestrian refuge(a small raised and protected island)in the middle of the busy road ,where pedestrians can pause before continuing to cross,not only clearly indiacates where to cross,but also makes crossing much easier and safer.

Forgiving roads protect road users in the event of an accident.Road design must recognise that accidents can occur and ensure that injuries and fatalities are minimised.For example,simple engineering features like safely barriers can be used to separate fast moving vehicles from people.Similarly,crash cushions can be used to reduce the consequences of an accident.

While increased mobility is essential for economic development and the relief of poverty,it should not be at the cost of escalating fatality rates among the poorer and most vulnerable sections of society.Appropriate action needs to be taken that simultaneously addresses vehicles,user behaviour and the design of the roads themselves.A key part of the solution lies in accessing the networks of metropolitan cities and identifying those dysfunctional roads on which large numbers of road users are being killed or seriously injured.These roads should then be targeted for safety upgrading through affordable,cost effective measures.

Read more...

Indian Design Guidelines(IRC103-1988)

Read more...

Advertorial: How to make your road trips safe(Source IBN live)

Tuesday, August 10, 2010

Road safety is an issue of key concern for both the government and the people on Indian roads. Safe driving requires a higher level of confidence and competence, given the poor traffic planning, increasing number of vehicles, and lack of civic driving sense and untrained drivers on the road.

Maruti Suzuki India Ltd. promotes safe driving and ensures safety of the people by taking all measures for road safety awareness.

A few points shared below, can help us maintain safety of self and those riding with us. These tips help you become a smart and responsive driver.

More Mileage, More Fun

Drive between 45 and 55 kmph -- It has been established by trials that you can get up to 40 per cent extra mileage at 40 kmph as compared to 80 kmph.

Avoid accelerating or decelerating unnecessarily. Incorrect gear shifts can lead to as much as 20% increase in fuel consumption -- For city driving, change to a higher gear when you are sure that the engine will not have to struggle.Get into top gear as soon as possible.

Check wheels for free rotation when your car is being serviced. Binding brakes restrict free wheel movement and the engine consumes more petrol in order to overcome resistance.

Use your clutch only when you change gears. Riding the clutch causes loss of energy and damages the clutch lining.

You can save as much as 6 per cent fuel through regular tuning of car. If your engine emits black or dark grey smoke, has poor pulling power or consumes large quantities of oil, have it checked immediately at an authorised service station.

Your air filter prevents air from fouling the engine. Dust causes rapid wear of engine components and increases fuel consumption.

Make sure that the fuel tank cap has a good rubber seal. Unnecessary loads increase fuel consumption. A reduction of weight by about 50 kg can lead to a 2 per cent saving in fuel, when driving in the city.

Under inflated tyres increase rolling resistance which leads to higher petrol consumption and faster wear of tyres at the sides.

Better Maintenance, Longer Drive

Do all preventive maintenance of your vehicle and stick to the maintenance schedule -- If you notice any fault, consult your service station.

Daily pre-driving checks must be carried out by all drivers, both inside the vehicle and outside.

High-Speed Watchout

Stopping distance progressively increases with vehicle speed. Apply the brakes far before of the stopping point to allow for the extra stopping distance.

At high speeds, the vehicle may be affected by side winds. Therefore, reduce speed and be prepared for unexpected buffeting, which can occur at the exits of tunnels, when passing by a cut of a hill, or when being overtaken by large vehicles, etc.

Read more...

SOME MAJOR TRAFFIC VIOLATIONS AFFECTING SAFETY

Wednesday, June 23, 2010

Red Light Jumping: You feel that by jumping red light you are saving upon your time. But it is not so. In fact you are losing it and playing with your life and is getting yourself booked under the law


Improper & Obstructive Parking: No parking should be done on road, except when specifically permitted by a direction on a board. Don’t blame when you are stuck in traffic jam next time, some among you may have parked obstructively on the road.


Violation of Mandatory Signs: There are certain mandatory signs, violation of which may put you in trouble. These are entering a one-way road from the opposite side, taking a right turn or left turn at places where it is prohibited, and blowing of horn where it is prohibited


Overtaking: On certain roads overtaking is strictly prohibited. These are the ones where the volume of traffic is very high. When overtaking on roads where it is not prohibited you should exercise great caution and put your power of judgement to its proper use.


Drunken Driving: Drunken driving is the gravest of all traffic offences. It is dangerous not only for you but also for other road users.

Read more...

Know the Road Markings 2

Thursday, June 3, 2010

Single Yellow Line: You cannot cross this line except while turning Right or taking a U-Turn.


Box Junction: A rectangular box with yellow crossed diagonal lines. Vehicles are not supposed to stop at this even for a brief period. Vehicles should cross it only if they have a clear space available ahead of the yellow box.


Stop Line: A single solid transverse line at the intersection. If the light signal is red or the traffic officer signals to ’Stop’ one is to stop the vehicle before this line.


Zebra Crossing: Alternate black and white stripes painted parallel to the road for pedestrians to cross the road when signals indicate so. Vehicles must stop and give way to pedestrians at these crossings. Pedestrian crossings are marked to facilitate and give the right of way to pedestrians.

Read more...

KNOW THE MARKINGS ON ROAD

Tuesday, May 25, 2010

All lines, patterns, words and colours applied on or attached to the road surface or kerbs are road markings. These are meant to direct, guide and regulate the road users. They are, in fact, the languages of road.

Centre Line: This white broken line divides the road into two, separating opposing stream of traffic. This line can be crossed if overtaking is essential provided the oncoming carriageway is clear

Double White/Yellow Lines:
These divide the road into two and overtaking/crossing these lines from both side and U-turn is strictly prohibited.
White less than and greater than signs: This indicates to slow down and proceed carefully. This road marking is generally found on roads near a school, college or hospital.

Small Broken White Lines:These demarcate the lanes on a road. Vehicles are supposed to move in between these lines. The left most lane is for buses, heavy vehicles and slow moving vehicles. The middle lane is for LMVs, scooters & motor cycles & the right most lane is for overtaking & turning right.

Parking prohibited Lines:Continuous single yellow/white line at the edge of the carriageway indicates that no vehicle can be parked but vehicle can be stopped along such a road. Continuous double yellow/white lines indicate that both parking and stopping are prohibited.

Read more...

WHAT DOES TRAFFIC SIGNALS INDICATE?

Tuesday, April 27, 2010

RED means STOP
Wait behind the stop line or cross walk.

If there are no lines, stop before the traffic light at the intersection so that traffic light is clearly visible.
Wait until a green signal appears before proceeding.

AMBER means CAUTION

You may move on if the amber appears after you have already crossed the stop line or when you feel that your stopping may cause accident. Anyhow be careful.

GREEN means GO

Proceed ahead ensuring that the way is clear

You can make a right or left turn if not prohibited by signs, but take special care and give way to pedestrians crossing the road.
FLASHING RED

Generally provided at level crossings, bridges, airfield, fire stations, minor roads, etc.

It means you must come to a full stop and proceed cautiously after making a safety check on all approaching traffic.

FLASHING YELLOW


Generally provided where major roads meet minor roads.

Slow down and proceed with caution, giving due attention to other traffic and pedestrians.

Read more...